[Mar-2025] Feel Fortinet FCSS_NST_SE-7.4 Dumps PDF Will likely be The best Option
FCSS_NST_SE-7.4 exam torrent Fortinet study guide
NEW QUESTION # 24
Refer to the exhibit, which shows the output of get router info bgp summary.
Which two statements are true? (Choose two.)
- A. The local FortiGate has received 18 packets from a BGP neighbor.
- B. The local FortiGate is still calculating the prefixes received from BGP neighbor 100.64.2.264
- C. The TCP connection with BGP neighbor 100.64.2.254 was successful.
- D. The local ForliGate has received one prefix from BGP neighbor 100.64.1.254.
Answer: A,D
NEW QUESTION # 25
Exhibit.
Refer to the exhibit, which shows the output of a session. Which two statements are true? (Choose Iwo.)
- A. The TCP session has been successfully established.
- B. The session is being offloaded.
- C. The session is being inspected using flow inspection.
- D. The session was initiated from an authenticated user.
Answer: A,D
NEW QUESTION # 26
In which two slates is a given session categorized as ephemeral? (Choose two.)
- A. A UOP session with packets sent and received
- B. A TCP session waiting for FIN ACK
- C. A TCP session waiting for the SYN ACK
- D. A UDP session with only one packet received
Answer: C,D
NEW QUESTION # 27
Which two statements about conserve mode are true? (Choose two.)
- A. FortiGate starts taking the configured action for new sessions requiring content inspection when the system memory reaches the configured red threshold.
- B. FortiGate exits conserve mode when the system memory goes below the configured green threshold.
- C. FortiGate starts dropping all new sessions when the system memory reaches the configured red threshold.
- D. FortiGate enters conserve mode when the system memory reaches the configured extreme threshold.
Answer: A,B
NEW QUESTION # 28
Refer to the exhibit, which shows partial outputs from two routing debug commands.
Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?
- A. Set snat-route-change to enable.
- B. Set the priority of the static default route using port1 to 10.
- C. Set preserve-session-route to enable.
- D. Set the priority of the static default route using port2 to 1.
Answer: B
NEW QUESTION # 29
Refer to the exhibit, which shows the output ofa debug command.
Which two statements about the output are true? (Choose two.)
- A. There are a total of five OSPF routers attached to the vorz4 network segment
- B. In the network connected to port4, two OSPF routers are down.
- C. The interlace is part of the OSPF backbone area.
- D. One of the neighbors has a router ID of 0.0.0.4.
Answer: B,C
NEW QUESTION # 30
Exhibit.
Refer to the exhibit, which shows two entries that were generated in theFSSO collectoragent logs.
What three conclusions can you draw from these log entries? {Choose three.)
- A. The user's status shows as "not verified" in the collector agent.
- B. Remote registry is not running on the workstation.
- C. DNS resolution is unable to resolve the workstation name.
- D. The FortiGate firmware version is not compatible with that of the collector agent.
- E. A firewall is blocking traffic to port 139 and 445.
Answer: A,B,E
NEW QUESTION # 31
Refer to the exhibit, which shows the omitted output of a session table entry.
Which two statements are true? (Choose two.)
- A. The traffic matches Policy ID 1.
- B. The traffic has been tagged for VLAN 0000.
- C. NP7 is handling offloading of this session.
- D. The session has been offloaded.
Answer: C,D
NEW QUESTION # 32
In IKEv2, which exchange establishes the first CHILD_SA?
- A. CREATE_CHILD_SA
- B. INFORMATIONAL
- C. IKE_Auth
- D. IKE_SA_INIT
Answer: A
NEW QUESTION # 33
Which statement aboutprotocol options is true?
- A. Protocol options give administrators a streamlined method to instruct FortiGate to block all sessions corresponding to disabled protocols.
- B. Protocol options allow administrators to configure a maximum number of sessions for each configured protocol.
- C. Protocol options allow administrators to configure the Any setting for all enabled protocols, which provides the most efficient use of system resources.
- D. Protocol options allow administrators to configure which Layer 4 port numbers map to upper-layer protocols, such as HTTP, SMTP, FTP, and so on.
Answer: D
NEW QUESTION # 34
Exhibit.
Refer to the exhibit, which shows a FortiGate configuration.
An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however the web filter is not inspecting any traffic that is passing through the policy.
What must the administrator do to fix the issue?
- A. Disable webfilter-force-off.
- B. Enable fortiguard-anycast.
- C. Change protocol to TCP.
- D. Increase webfilter-timeout.
Answer: A
NEW QUESTION # 35
Consider the scenario where the server name indication (SNI) does not match either the common name (CN) or any of the subject alternative names (SAN) in the server certificate.
Which action will FortiGate take when using the default settings for SSL certificate inspection?
- A. FortiGate uses the SNI from the user's web browser.
- B. FortiGate closes the connection because this represents an invalid SSL/TLS configuration.
- C. FortiGate uses the first entry listed in the SAN field in the server certificate.
- D. FortiGate uses the ZN information from the Subject field in the server certificate.
Answer: C
NEW QUESTION # 36
Exhibit.
Refer to the exhibit, which contains a screenshot of some phase 1 settings.
The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:
However, the IKE real-time debug does not show any output. Why?
- A. The log-filter setting is incorrect. The VPN traffic does not match this filter.
- B. Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.
- C. The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.
- D. The administrator must also run the command diagnose debug enable.
Answer: D
NEW QUESTION # 37
Refer to theexhibit,which shows the output of getrouter info ospf neighbor.
What can you conclude from the command output?
- A. The local FortiGate is not a DROther.
- B. The network type connecting the local Fortigate and OSPF neighbor 0.0.0.10 is point-to-point.
- C. The local FortiGate is the BDR.
- D. All neighbors are in area 0.0.0.0.
Answer: B
NEW QUESTION # 38
Refer to the exhibit, which shows a truncated output of a real-time LDAP debug.
What two conclusions can you draw from the output? (Choose two.)
- A. FortiOS is performing the second step (Search Request) in the LDAP authentication process.
- B. The name of the configured LDAP server is Lab.
- C. FortiOS is able to locate the user in step 3 (Bind Request) of the LDAP authentication process.
- D. The user is authenticating using CN=John Smith.
Answer: A,D
NEW QUESTION # 39
Refer to the exhibit.
Assuming a default configuration, which three statements are true? (Choose three.)
- A. User A: Pass. The default static route through wan1 passes the RPF check regardless of the source IP address.
- B. User B: Fail. There is no route to 95.56.234.24 using wan2 in the routing table.
- C. Strict RPF is enabled by default.
- D. User B: Pass. FortiGate will use asymmetric routing using wan1 to reply to traffic for 95.56.234.24.
- E. User C: Fail. There is no route to 10.0.4.63 using port1 in the touting table.
Answer: B,D,E
NEW QUESTION # 40
......
Use Valid New FCSS_NST_SE-7.4 Test Notes & FCSS_NST_SE-7.4 Valid Exam Guide: https://www.free4dump.com/FCSS_NST_SE-7.4-braindumps-torrent.html
FCSS_NST_SE-7.4 Actual Questions Answers PDF 100% Cover Real Exam Questions: https://drive.google.com/open?id=1zh7G2s0SpebeeGgLVlBf7vxy7ZlbCCNi