Achieve The Utmost Performance In 201-450 Exam Pass Guaranteed [Q39-Q58]

Share

Achieve The Utmost Performance In 201-450 Exam Pass Guaranteed

Achive your Success with Latest Lpi 201-450 Exam


The 201-450 exam, otherwise known as LPIC-2 Exam 201, is the first professional certification test in the multi-level program conducted by open-source support and global certification organization, Linux Professional Institute (LPI). The objective of this exam is to test the skills and knowledge of candidates to perform advanced system administration of small to medium-sized mixed networks. The array of topics tested is wide, varying, and usually random so, a lot of time will be needed to prepare for the 201-450 exam. But before you set the goal to get the LPIC-2 certification, that you can earn by passing 201-450 and 202-450 exams, you need to possess the LPIC-1 certificate.

 

NEW QUESTION 39
Due to extreme system use, a Linux system requires some additional swap space. To initialize 5 GB of additional swap space, which combination of commands should be used?

  • A. touch -5G /tmp/swapfile; swapon /tmp/swapfile
  • B. dd if=/dev/zero of=/tmp/swapfile bs=1024 count=5120000; swapon /tmp/swapfile
  • C. dd if=/dev/zero of=/tmp/swapfile bs=1024 count=5120000; mkswap /tmp/ swapfile; mount /tmp/swapfile
  • D. mkswap /tmp/swapfile 512000; swapon /tmp/swapfile
  • E. dd if=/dev/zero of=/tmp/swapfile bs=1024 count=5120000; mkswap /tmp/ swapfile; swapon /tmp/swapfile

Answer: E

 

NEW QUESTION 40
Which of the following terms are used to describe 3.x kernel releases? (Choose TWO correct answers.)

  • A. longterm
  • B. final
  • C. stable
  • D. prerelease
  • E. beta

Answer: A,C

 

NEW QUESTION 41
Due to extreme system use, a Linux system requires some additional swap space. To initialize 5GB of additional swap space, which combination of commands should be used?

  • A. touch -5G /tmp/swapfile; swapon /tmp/swapfile
  • B. dd if=/dev/zero of=/tmp/swapfile bs=1024 count=5120000; swapon /tmp/swapfile
  • C. dd if=/dev/zero of=/tmp/swapfile bs=1024 count=5120000; mkswap /tmp/swapfile; swapon /tmp/swapfile
  • D. dd if=/dev/zero of=/tmp/swapfile bs=1024 count=5120000; mkswap /tmp/swapfile; mount
    /tmp/swapfile
  • E. mkswap /tmp/swapfile 512000; swapon /tmp/swapfile

Answer: C

 

NEW QUESTION 42
In case the file containing the Linux kernel is lost, what happens when the system is booting?

  • A. The system starts normally since the bootloader copies the kernel to the master boot record of the hard disk.
  • B. The bootloader mounts the root filesystem read-only and launches /bin/sh directly in order to allow the administrator to reinstall the kernel.
  • C. Without a kernel a system cannot boot and, depending on the bootloader, an error is displayed.
  • D. Instead of the kernel, the initramfs is loaded and instructed to mount the root filesystem and reinstall the kernel from the original package or from source.

Answer: C

 

NEW QUESTION 43
After changing the default runlevel in the SysV-init configuration file, the system boots in a different than intended runlevel. Where else could this different runlevel be defined?

  • A. In the /etc/sysctl.conf
  • B. In the /etc/rc.d/rc.local file
  • C. In the /boot/initramfs file
  • D. In the boot loader configuration file
  • E. In the /etc/runlevel file

Answer: D

 

NEW QUESTION 44
How can the label rootbe added to the ext4 filesystem on /dev/sda1?

  • A. tune2fs -L root /dev/sda1
  • B. echo 'root' > /proc/fs/sda1/label
  • C. relabel /dev/sda1 root
  • D. labelfs --device /dev/sda1 root

Answer: A

 

NEW QUESTION 45
What should be done to ensure a client machine uses the recursive nameserver running on the IP address 192.168.0.1? (Choose TWO correct answers.)

  • A. Ensure that the dns service is listed in the hosts entry in the /etc/nsswitch.conf file.
  • B. Run bind add nameserver 192.168.0.1.
  • C. Run route add nameserver 192.168.0.1.
  • D. Add nameserver 192.168.0.1 to /etc/resolv.conf.
  • E. Run ifconfig eth0 nameserver 192.168.0.1.

Answer: A,D

 

NEW QUESTION 46
In this example output, which descriptions match the purpose of the free, buff and cache columns? (Choose THREE correct answers.)
# vmstat 1 100
procs -----------memory---------- ---swap-- -----io---- --system-- ----cpu---- r b swpd free buff cache si so bi bo in cs us sy id wa
0 0 0 282120 134108 5797012 0 0 0 2 0 0 0 0 100 0
0 0 0 282120 134108 5797012 0 0 0 0 1007 359 0 0 100 0
0 0 0 282120 134108 5797012 0 0 0 0 1117 577 0 0 100 0
0 0 0 282120 134108 5797012 0 0 0 0 1007 366 0 0 100 0

  • A. RAM available for filesystem buffers
  • B. Used swap space
  • C. Available free RAM
  • D. RAM used for filesystem cache
  • E. RAM used for buffers

Answer: C,D,E

 

NEW QUESTION 47
In the following output, the load averages represent the system load averages for what time frames?
12:10:05 up 18 days, 19:00, 2 users, load average: 0.47, 24.71, 35.31

  • A. 15, 30 and 60 minutes
  • B. 1, 15 and 30 minutes
  • C. 1, 5 and 15 minutes
  • D. 1, 15, and 30 seconds
  • E. 15, 30 and 60 seconds

Answer: C

 

NEW QUESTION 48
Which of the following configuration files are used by tcpwrapper?

  • A. /etc/service.allow and /etc/service.deny
  • B. /etc/tcpd.allow and etc/tcpd.deny
  • C. /etc/tcpwrapper.allow and /etc/tcpwrapper.deny
  • D. /etc/hosts.allow and /etc/hosts.deny

Answer: D

 

NEW QUESTION 49
Which command will report information on memory usage, paging and block input/output?

  • A. memshow
  • B. top
  • C. ps
  • D. vmstat
  • E. free

Answer: D

 

NEW QUESTION 50
Which of the following commands can be used to list IPv4 addresses and MAC addresses for IP devices that the system has seen on the local network?

  • A. iwlist
  • B. ifconfig
  • C. arp
  • D. ipadm

Answer: C

 

NEW QUESTION 51
After the downloading patch-4.6.4.xz from http://kernel.org, what are the next steps to prepare the build of a version 4.6.4 Linux kernel? (Choose two.)

  • A. Use patchto apply the uncompressed patch file to the source directory of any previous kernel version
  • B. Apply the patch file to the kernel source directory containing kernel version 4.6.3
  • C. Apply the patch file to the kernel source directory containing kernel version 4.6.0
  • D. Uncompress the file using xzto get the uncompressed patch file
  • E. Uncompress the file and move the resulting directory to /usr/src/linux

Answer: A,D

 

NEW QUESTION 52
Which of the following files will be looked for and used by GNU make, if one of them exists, unless a different file is specified on the command line when trying to compile software from source code? (Choose two.)

  • A. Makefile.in
  • B. Makefile
  • C. configure
  • D. makefile
  • E. config.h.in

Answer: B,D

 

NEW QUESTION 53
The following is an excerpt from the output of tcpdump -nli eth1:

Which network service or protocol was used?

  • A. DHCP
  • B. FTP
  • C. SSH
  • D. DNS
  • E. HTTP

Answer: B

 

NEW QUESTION 54
What is the command to add another IP address (192.168.1.2) to a network interface (eth0) that already has (at least) one IP address in the 192.168.1.0/24 subnet?

  • A. ip addr add 192.168.1.2/32 dev eth0
  • B. ipconfig eth0 192.168.1.2
  • C. ifconfig eth0 192.168.1.2 netmask 255.255.255.255
  • D. ip add addr 192.168.1.2/32 dev eth0

Answer: A

 

NEW QUESTION 55
What effect does the -foption to the update-rc.dcommand have on files in the /etc/rcX.d/and / etc/init.d/directories?

  • A. It will force the removal of the symlinks in /etc/rcX.d/even when the links are read only
  • B. It will remove the init script in /etc/init.d/and the symlinks in /etc/rcX.d/and update the package information of installed files
  • C. It will remove both the symlinks in /etc/rcX.d/and the init script in /etc/init.d/
  • D. It will force the removal of symlinks in /etc/rcX.d/even if the corresponding init script still exists in / etc/init.d/

Answer: D

 

NEW QUESTION 56
Which of the following are common Linux filesystem types used for root partitions?
(Choose THREE correct answers.)

  • A. VFAT
  • B. ext4
  • C. Btrfs
  • D. XFS
  • E. NTFS

Answer: B,C,D

 

NEW QUESTION 57
Which commands below are useful to collect data about remote filesystem connections? (Choose two.)

  • A. fsiostat
  • B. pidstat
  • C. cifsiostat
  • D. sadf
  • E. nfsiostat

Answer: C,E

 

NEW QUESTION 58
......


What Is LPI 201-450 Test?

Overall, it is a multi-professional certification exam that manages small to medium-size networks. This exam comes in English, Japanese, German, and Portuguese (Brazilian). To add more, to register for it, you have to pay $200 if you're a USA citizen. Note, that this price changes from one country to another. Simply put, 201-450 is a 90-minute long test that has 60 fill-in-the-blank and multiple-choice items. After taking this exam together with the second obligatory validation, you will see more opportunities for you within the IT field.

 

Revolutionary Guide To Exam Lpi Dumps: https://www.free4dump.com/201-450-braindumps-torrent.html

The 201-450 Exam Test For Brief Preparation: https://drive.google.com/open?id=1-MYRq5ju7SBx7HIRM6BkrVB9qExLpyQk